Hitachi RWM-(H)FSN3E, Руководство по обслуживанию

Страница: 185 / 424

5 Control system
SMGB0070 rev. 1 - 08/2011
175
5
Š
You now have a choice of how to set the program for the next day:
f. i) Press the button to copy Monday’s program into Tuesday. The display will go blank apart from the ‘non flashing’
day indicator, which indicates the day copied and the ‘flashing’ target day to copy the program to. To accept this
day press the green button. To select a different target day press the button until the ‘flashing’ day indicator
is under the required day, then accept it by pressing the green button.
N O T E
Once the target day is confirmed it becomes the day that is copied if the button is pressed again.
OR
g. ii) Press the 1 button to move the day indicator to Tuesday (Day 2). The program for that day can then be adjusted
by following steps b to e. Programs for the remaining days can be set in the same way, using the 1 button to move
to the next day.
To exit the programming mode select the desired operating mode by pressing the , or buttons.
N O T E
To run the adjusted program select the AUTO mode.
• Disabling / Enabling Time Periods
The Room Unit has 6 periods each day that can be programmed, but you may not need all of these switch points for your
heating requirements. Therefore, any period from 2 to 4 can be removed from (or returned to) the heating program profile.
Š
To disable or enable time periods:
a. To disable unwanted periods go to the desired period ( 2 to 6 ) using the PROGRAM or buttons to navigate,
ensure the correct period is highlighted with the flashing square symbol. Press and hold the button for at least 2
seconds and the display will indicate the period has been removed from the program.
b. To enable periods again follow the same procedure as above, navigating to the already disabled period. To enable
this period again press and hold the button for at least 2 seconds.
• Choosing the Operating Mode
The Room Unit can operate in three different modes: Automatic, Manual or Off. To set the operating mode press either of
the , or buttons. The screen indicates which mode is currently active by displaying AUTO, MAN or OFF.
AUTOMATIC ( ) mode sets the Room Unit to follow the built-in temperature program (default or personalised). Operating
the Room Unit in this mode is the best way to maintain a high level of temperature comfort whilst maximising your energy
savings.
MANUAL ( ) mode allows the Room Unit to be used without following the builtin temperature programme. The setpoint
can be adjusted from 5°C to 35°C by using the or buttons. The Room Unit will continue to maintain this temperature
until another operating mode or temperature is selected.
OFF ( ) mode sets the Room Unit to control to a minimum temperature setting of 5°C (default) that acts as a frost protec-
tion measure for your home.