Hitachi RWM-(H)FSN3E, Руководство по обслуживанию

Страница: 180 / 424

5 Control system
SMGB0070 rev. 1 - 08/2011
170
Binding/Rebinding Procedure (Intelligent thermostat) (ATW-RTU-02/03)
Binding is a necessary process in order to link the room thermostat with the wireless receiver and assign them to the co -
rresponding circuit on the YUTAKI S controller.
Make sure the room thermostats are shut down before starting the binding process. They must be in the Off position.
First, reset the wireless receiver by holding down the button for
15 seconds. This will erase the receiver’s current configuration.
Next, prepare the wireless receiver to link it to the room thermos
-
tat and unit. Press and hold the receiver button for 5 seconds.
Next, select the circuit to be linked inside the binding zone. Af -
ter selecting between the two circuits the following window will
appear.
BINDING CIRCUIT 1
CANCEL START
Pressing start will begin the binding mode in the room unit. It will
blink each second during the specified binding time. When bin -
ding is finished a success message will appear.
BINDING CIRCUIT 1
BINDING WITH CIRCUIT 1
CANCEL
Next, activate binding mode on the room thermostat. Refer to the
thermostat manual for instructions. After activation, confirm by
pressing the OK button.
After that, if binding is completed, the following message will
appear on the
YUTAKI S
controller.
BINDING CIRCUIT 1
BINDING COMPLETE
ACCEPT
If binding fails, the “BINDING FAILURE” error message will appear.