Hitachi RAS-(2-6)HVNP1(E), Руководство по обслуживанию

Страница: 77 / 498

3 Piping work and
refrigerant charge
63
SMGB0087 rev.0 - 12/2013
3
C A U T I O N
• Cap the end of the pipe when pipe is to be inserted through a wall hole.
• Do not put pipes on the ground directly without a cap or vinyl tape at the end of the pipe.
• If piping installation is not completed until next day or over a longer period of time, braze off the ends of the piping and
charge with oxygen free nitrogen through a Schrader valve type access fitting to prevent moisture and particle conta-
mination.
• Do not use insulation material that contains NH3, as it can damage copper pipe material and become a source of future
leakage.
• Insulate the unions and flare-nuts at the piping connection part completely.
• Completely insulate both refrigerant gas and liquid piping between the indoor unit and the outdoor unit to avoid a de-
crease of performance; if not, dew will occur on the piping surface.
• Refrigerant circuit and Water circuit must be performed and inspected by a licensed technician and must comply with
all relevant European and national regulations.

Insulation
Attach the pipe insulation to each branch using vinyl tape. Attach also insulation to field supplied pipes in order to prevent
the capacity decrease according to the ambient air conditions and dewing on the low pressure pipe surface.
1. Cap.
2. Field supplied insulation.
3. Do not make a gap.
N O T E
When polyethylene foam is applied, it is recommended
the usage of a wall thickness of 10 mm for the liquid
piping and 15 mm to 20 m for the gas piping.
1
2
1
1
3
C A U T I O N
• Perform the insulation work after the pipe surface temperature decreases to the room temperature, if not the insulation
material may melt.
• If the ends of the piping system are open after ending the piping work, attach caps or vinyl bags securely to the ends
of the piping, avoiding moisture and dust entering.