Hitachi RAS-(2-6)HVNP1(E), Руководство по обслуживанию

Страница: 394 / 498

10 Servicing
380
SMGB0087 rev.0 - 12/2013
10.4.12 Removing solenoid valve coil (SVA and SVC)
1 Remove the service cover and the upper cover following
“10.4.1 Removing service cover” and “10.4.3 Removing upper
cover” .
2 Unplug the connector PCN7 (SVA) and PCN14 (SVC) on O.U.
PCB1.
3
Remove the fixing screw, and remove the solenoid valve coils
(SVA and SVC) upward.
4 When reassembling after replacing the solenoid valve coil, per-
form the procedure in the reverse way of removing.
N O T E
Fix the wires by plastic bands to the original position.
Solenoid Valve Coil (SVC)
Fixing Screws for Solenoid Valve Coil
Solenoid Valve Coil (SVA) (Only for 4 to 7HP)
Solenoid valve coil (SVC)
Solenoid valve coil screw
Solenoid valve coil (SVA)
10.4.13 Removing reversing valve
1 Remove the service cover, the bottom service cover, the rear cover
and the upper cover following
“10.4.1 Removing service cover” ,
“10.4.4 Removing the bottom service cover and rear cover” and
“10.4.3 Removing upper cover” .
2
Recover the refrigerant from check joints according to “10.4.7 Re-
moving the compressor”
.
3 Remove the reversing valve coil according to
“10.4.10 Removing
Reversing valve coil” .
4 Remove the reversing valve assemblies from the fixed positions
(5 brazing parts).
a. Remove the reversing valve and the stop valve with cooling the
valve bodies by wet cloth.
b. Perform the brazing work with attention not to burn the electri-
cal wirings and the piping insulations.
5 Remove reversing valve from the assemblies. (5 brazing parts) At
this time, perform the brazing work with cooling the reversing valve
body by wet cloth.
6
When reassembling after replacing the reversing valves, perform
in the reverse procedure of removing.
a. Run the lead wires to be located to the original position, and fix
them by the plastic band.
b. Attach the crankcase heater according to “10.4.7 Removing
the compressor” .
5 brazing
parts