Hitachi RAS-(2-6)HVNP1(E), Руководство по обслуживанию

Страница: 471 / 498

11 Electrical checks of
main parts
457
SMGB0087 rev.0 - 12/2013
11
11.1.3 Protective function
1 Excessive high or low voltage for inverter
a. Level of detection
• When the voltage of direct current is greater than (A)
• When the voltage of direct current is smaller than (B)
Power supply 3N ~ 400V 50Hz 1 ~ 230V 50Hz
(A) 750 Volts 376 Volts
(B) 350 Volts 194 Volts
b. Function
When abnormalities are detected the inverter compressor is stopped and transmit the signal code of stoppage
cause to PCB1.
c. Cancellation of protection function.
Transmission for signal code of stoppage cause is cancelled when a stopping order is given or main power source
is cut off.
2 Abnormality of current sensor
a. Level of detection
When current of the inverter compressor decreases lower than 1.5A during the inverter compressor frequency
between 15Hz and 18Hz an abnormality is detected.
b.
Function
When abnormalities are detected the inverter compressor is stopped and transmit the signal code of stoppage
cause to PCB1.
c. Cancellation of Protection Function
Transmission for signal code of stoppage cause is cancelled when a stopping order is issued or main power sour-
ce is cut off.
3 Overcurrent protection for inverter
a. Level of detection
Š
When the current detected by current sensor reaches 150% of the rated current overcurrent is detected. (Ins-
tantaneous overcurrent).
Š
When the current detected by current sensor exceeds 105% of the rated current continuously for 30 seconds or
for 3.5 minutes in total during a 10 minutes period overcurrent is detected. (Electric thermal relay).
b. Function
When abnormalities are detected the inverter compressor is stopped and transmit the signal code of stoppage
cause to PCB1.
c. Cancellation of protection function
Transmission for signal code of stoppage cause is cancelled by stopping order is issued or main power source is
cut off.
4 Protection of IPM/DIP-IPM/ISPM
a. Level of detection
Š
When some of the output terminals “U”, “V” or “W” of IPM/DIP-IPM/ISPM are short-circuited an abnormality is
detected.
Š
When the running current of IPM/DIP-IPM/ISPM reaches (maximum rated current x 105%) an abnormality is
detected.
Š
When an internal temperature is measured by internal thermistor of IPM an abnormality is detected. When the
control voltage of IPM/DIP-IPM/ISPM decreases an abnormality is detected.
b. Function
When abnormalities are detected the inverter compressor is stopped and the signal code of stoppage cause is
transmitted to PCB1.
c. Cancellation of protection function
Transmission for signal code of stoppage cause is cancelled when a stopping order is issued or main power sour-
ce is cut off.