Hioki MR8740, Инструкция по эксплуатации

Страница: 56 / 424

2.2 Connecting Cords
44
Attach to the measurement object
Connecting the 9769
1
Connect the 9769 to a terminal on the
input module.
The orange section of the 9769 must
face up.
2
Connect the strain gauge transducer to
the conversion cable.
3
Attach to the measurement object.
Example: Connecting the 9769 Conversion Cable with the supplied conversion cable
Required item:
9769 Conversion Cable, strain gauge transducer
Connect to input module's terminal
Connect to the strain gauge transducer
3
2
1
Applied voltage:
bridge voltage of 2 V
Connector Pinout of the 9769 on strain
gauge transducer side
The metal shell is connected to the GND of Model
8969.
Connector Pinout of the 8969
(1 is on left when unit top side is facing up)
Pin No. Description
1
2 SENSE+
3 INPUT+
4 INPUT-
5 BRIDGE-
6 SENSE-
7 FLOATING COMMON
Pin Mark Description
A
B INPUT-
C BRIDGE-
D INPUT+
E FLOATING COMMON
F, G N.C.
1 2 3 4 5 6 7
• Preforming measurement with a strain gauge requires a bridge box. Use a strain gauge and bridge box
both of which are commercially available.
• The bridge box may be susceptible to the effect of noise. For more information about how to ground the
bridge box, refer to its instruction manual or contact the manufacturer of the bridge box.
• Do not excessively bend the cable and the base between cable and connector, pull on them, nor twist
them. Doing so may cause the conversion cable to break.
8969 Strain Unit
Connection of Model L9769
• Pin F of the module end is connected with Pin A of the strain gauge transducer end.
• Pin G of the module end is connected with Pin C of the strain gauge transducer end.