Hioki MR8740, Инструкция по эксплуатации

Страница: 198 / 424

8.1 Setting Workflow
186
The procedure for making trigger settings is as follows.
8.1 Setting Workflow
Trigger Mode Settings
Set whether to continue to accept triggers after measuring. (p.187)
Trigger Type Settings
Make trigger source-related settings.
• Analog trigger
• Logic trigger
• Timer trigger
• External trigger
• Manual trigger
(p.188)
(p.193)
(p.195)
(p.199)
(p.199)
Pre-Trigger Settings
Set the amount to record before and after a trigger point.
( p.200)
Setting AND/OR Between Trigger
Sources
Select AND/OR logical combination of analog, logic, external
and timer triggers to be applied.
( p.204)
Start Measurement
Click [START] in the right-click menu to start measuring.
(However, operation differs according to the setting for Start Action
(p.307).)
Data acquisition starts when trigger criteria are met.
To stop measurement: Click [STOP] in the right-click menu.
Click once: recording stops at the end of the specified recording length.
Click twice: recording stops immediately.
Available settings for the respective items depend on the function.
• Except for manual trigger, triggering is based on the AND/OR combination of
trigger sources. (p.204)
• When triggering occurs, the TRIG OUT terminal for control of external devices
carries an output signal. (p.339) (MR8741 only)
• Settings for the analog trigger are restricted for the channel of the MR8990
Digital Voltmeter Unit.
• When MR8990 Digital Voltmeter Unit is installed, the trigger position may be
offset by 1 point.