Hardware Installation and Uninstalling
104/299
PC Cards cifX Compact PCI, Mini PCI, Mini PCIe, PCI-104 | Installation, Operation and Hardware Description
DOC120205UM53EN | Revision 53 | English | 2019-03 | Released | Public
© Hilscher, 2008-2019
¾
Place the finger centrally on the edge of the heat sink (
see figure
).
Figure 51: Press down the basic card with light pressure (max. 2 N) (example)
¾
Guide the basic card downwards with light pressure (max. 2 N).
Depending on the type of fastening:
•
Locking hooks
¾
Guide the basic card when snapping in (see
in figure), because
of, the locking hooks could tilt.
Figure 52: Example: Fastening with locking hooks, guide basic card when snap-in
•
Screw
¾
Screw on the basic card to the main board.
•
Clamps
¾
Press down the clamps until they snap into place.
Connect AIFX detached Network Interface
Important!
Operating the PC cards
Mini PCI
CIFX 90-RE\F, CIFX 90-
RE\F\M12, CIFX 90-DP\F, CIFX 90-CO\F and CIFX 90-DN\F or the PC
cards
Mini PCI Express
CIFX 90E-XX\F (all variants ‘NHS’, ‘ET’, ‘MR’ or
with ‘M12’)
requires proper connection of the Ethernet (AIFX-RE or AIFX-
RE\M12), PROFIBUS (AIFX-DP), CANopen (AIFX-CO), DeviceNet (AIFX-
DN) or CC-Link (AIFX-CC) detached network interface to the basic card!
For 2-channel devices both detached network interfaces must be
connected.
Note:
If IP 67 is requried: On the Ethernet AIFX-RE\M12 detached
network interface, remove the front LED lightpipe and route the LED
signals via the cable connector LED signals X3 to the mainboard or a
separate detached LED board.
4
CIFX 90E-XX\NHS\F, CIFX 90E-XX\ET\F, CIFX 90E-XX\MR\F or CIFX 90E-
XX\MR\ET\F (XX = RE, DP, CO, DN or for the variants ‘NHS’, ‘ET’ and ‘MR\ET’
also = CC); or CIFX 90E-RE\F\M12, CIFX 90E-RE\NHS\F\M12, CIFX 90E-
RE\ET\F\M12, CIFX 90E-RE\MR\F\M12, CIFX 90E-RE\MR\ET\F\M12
