Hewlett Packard Enterprise ProLiant ML350 Gen10, Руководство пользователя

Страница: 68 / 214

For drive numbering, see Drive bay numbering.
• The NVMe SSD is a PCIe bus device. Devices attached to a PCIe bus cannot be removed without allowing the device
and bus to complete and cease the signal/traffic flow.
Do not remove an NVMe SSD from the drive bay while the Do not remove LED is flashing. The Do not remove LED
flashes to indicate that the device is still in use. Removal of the NVMe SSD before the device has completed and
ceased signal/traffic flow can cause loss of data.
• Drives with the same capacity provide the greatest storage space efficiency when grouped into the same drive array.
Installing an LFF non-hot-plug drive
Prerequisites
Before you perform this procedure:
•
Make sure that the LFF non-hot-plug drive cage is available.
• Make sure that you have the following items available:
◦ LFF non-hot-plug drive option
◦ T-15 Torx screwdriver
Procedure
1. Remove the front bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4.
Disconnect all peripheral cables from the server.
5.
Do one of the following:
• Server in tower mode: Position the tower server for hardware configuration.
• Server in rack mode: Extend the server from the rack.
6. Remove the access panel.
7. Remove the air baffle.
8.
If installed,
remove the fan cage.
9.
If the LFF non-hot-plug drive cage is already installed, do the following:
a. If there are drives already installed in the cage, disconnect the SATA-power split cable from the drives.
b. Remove the drive cage.
68
Hardware options installation