Hewlett Packard Enterprise ProLiant ML350 Gen10, Руководство пользователя

Страница: 145 / 214

Installing an M.2 SATA SSD
Prerequisites
Before you perform this procedure:
•
Make sure that the fan cage is installed.
• Make sure you have the following items available:
◦ M.2 SSD enablement option
◦ M.2 SSD
◦
T-15 Torx screwdriver
◦ Phillips No. 1 screwdriver – This is required only if the M.2 SSD is not preinstalled on the enablement board.
Procedure
1. Remove the front bezel.
2. Power down the server.
3.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
• Server in tower mode:
Position the tower server for hardware configuration.
• Server in rack mode:
Extend the server from the rack.
6. Remove the access panel.
7. Remove the air baffle.
8. Remove the PCI blank retainer.
9. Remove the PCI slot blank.
10. If the M.2 SSD enablement board option does not include a screw for installation, remove one of the preinstalled
PCI board screw.
11. If the SSD is not preinstalled on the M.2 SSD enablement board, do the following:
If only one SSD is being installed, install the SSD in slot 1.
a. Insert the SSD into the M.2 slot at a 45° angle.
b. Carefully press the SSD down to the horizontal position.
c. Install the SSD mounting screw.
Hardware options installation
145