176
9.
(Optional) You can click the <Copy> button to copy the cloud storage settings to other cameras.
You can also click the checkbox of <Analog/IP Camera> to select all cameras.
Click the <OK> button to go back to the <Cloud Storage> interface and click
<Apply> to finish
the settings.
14.6 Configuring a Disk Clone
Note:
This chapter is only applicable to the DVR models with eSATA.
If the S.M.A.R.T. detection result declares the HDD is abnormal, then you can choose to clone all
the data on the HDD to an inserted eSATA disk manually. Refer to
Chapter 14.8 Checking S.M.A.R.T.
Information
for details of S.M.A.R.T detection.
Before you start
An eSATA disk should be connected to the device.
Steps:
1.
Enter the <HDD Advanced Settings> interface:
Menu > HDD > Advanced
.
2.
Click the <Disk Clone> tab to enter the <Disk Clone Configuration> interface.
3.
Make sure the usage of the eSATA disk is set as <Export>.
If not, click the <Set> button to set it. Choose <Export> and click the <OK> button.
Note:
The capacity of the destination disk must be the same as that of the clone source disk.
4.
Check the checkbox of the HDD to be cloned in the <Clone Source> list.
5.
Click the <Clone> button and a message box pops up.
6.
Click the <Yes> button to continue.
You can check the clone progress in the HDD status.
14.7 Checking the HDD Status
You may check the status of the installed HDDs on the DVR so as to do an immediate check and
maintenance in case of an HDD failure.
Checking the HDD Status in the HDD Information Interface
Steps:
1.
Go to
Menu > HDD > General
.
2.
Check the status of each HDD which is displayed on the list, as shown below.
