Graco Horizon Fluid Management Systems, Инструкция по эксплуатации

Страница: 35 / 108

308607 35
System Setup -- Meter Calibration
Instructions
Set Meter Calibration
1. Cursor is in the METER NUMBER field.
2. The meter number will display according to the
order they were entered while assigning connec-
tions (page 34).
3. Press ENTER on the keypad.
4. Cursor moves to the CM# field.
5. Type the number of the control module that con-
trols the meter for this dispense point.
6. Press ENTER on the keypad.
7. Cursor moves to the PORT# field.
8. Type the number of the port the meter is con-
nected to (7--12).
9. Press ENTER on the keypad.
10. Cursor moves to the PULSES PER XX field.
11. Type the number of pulses (per unit of measure).
D
Only integers between 1 and 9999 will be
accepted for the calibration factor.
D
P/N 238618 Oil Meter has a nominal calibra-
tion factor of 200 pulses per quart (211 pulses
per liter).
D
P/N 215474 Meter (for antifreeze and washer
fluid) has a nominal factor of 10 pulses per
quart (11 pulses per liter).
D
Start with the nominal value and adjust the
value as needed to increase accuracy.
12. Press ENTER on the keypad.
13. When the cursor is at MORE, press ENTER to
repeat the screen for each meter.
-- Or move the cursor to EXIT to exit the connec-
tion assignment setup.
Save the Setup
Follow the Save Setup procedure on page 30.
Screens
METER NUMBER: 001
CM# 01 PORT# 07
0001 PULSES PER QT
MORE EXIT
METER NUMBER: 001
CM# 01 PORT# 07
0001 PULSES PER QT
MORE EXIT
METER NUMBER: 001
CM# 01 PORT# 07
0001 PULSES PER QT
MORE EXIT
METER NUMBER: 001
CM# 01 PORT# 07
0001 PULSES PER QT
MORE EXIT
METER NUMBER: 001
CM# 01 PORT# 6
0200 PULSES PER QT
MORE EXIT