gefran AD, Быстрый старт, технические характеристики и установка

Страница: 62 / 142

62
ADV200 WA • Quick start up guide - Specification and installation
This function permits access to any parameter entering only the software number
of the parameter (PAR).
When the parameter reached by the “Goto” command is displayed, it is possible
to navigate all the parameters forming part of the same group using the ▲ and ▼
keys.
Pressing the ► key returns to the “Goto” function.
To exit the “Goto” function, press the ► key.
6.3 Parameter modification
To enter parameter modification mode, press the E key when the parameter to be
modified is displayed.
To save the value of the parameter, following modification, press the E key again.
Note !
To save permanently, see
paragraph 6.4
.
To exit from modification mode without saving the value, press the ESC key.
The operations to be carried out to modify the value depend on the type of the
parameter, as described below.
Note !
For further information about the type of parameters displayed, see
chapter Parameters List (ADV200
WA FP manual)
.
●
Numeric parameters
T+ T- EN LOC ILim n:0 AL
13 DIGITAL OUTPUTS
14 ANALOG INPUTS
15 ANALOG OUTPUTS
16 MOTOR DATA
E
T+ T- EN LOC ILim n:0 AL
1 6 . 0 1 PA R : 2 0 0 0
Rated voltage
+
400
V
Def: +400
T+ T- EN LOC ILim n:0 AL
1 6 . 0 1 PA R : 2 0 0 0
Rated voltage
+
V
Def: +400
0 0 0 0 0 0 4 0 0
When E is pressed to access modification mode, the cursor is activated on the
digit corresponding to the unit.
Using the ◄ and ► keys, the cursor can be moved to all the digits, including trail-
ing zeros that are normally not displayed.
With the ▲ and ▼ keys, the digit under the cursor is increased or decreased.
Press E to confirm the modification or ESC to cancel.
● Binary parameters (BIT type)
The parameter may assume only two states which are indicated as OFF-ON or
0-1.
X 5
T+ T- EN LOC ILim n:0 AL
10 SPEED MONITOR FUNC
11 COMMANDS
12 DIGITAL INPUTS
13 DIGITAL OUTPUTS
E
T+ T- EN LOC ILim n:0 AL
1 3 . 0 5 PA R : 1 3 3 0
Dig out 1 inversion
ON
T+ T- EN LOC ILim n:0 AL
1 3 . 0 5 PA R : 1 3 3 0
Dig out 1 inversion
OFF
Pressing E , modification mode is activated. The entire line is displayed in reverse.
Use the ▲ and ▼ keys to move from one state to another.
Press E to confirm the modification or ESC to cancel.