GE HEALTHCARE CARESCAPE Monitor B650, Техническое руководство

Страница: 142 / 240

CARESCAPE Monitor B650
134
2062973-002
Configuring the monitor
1. Configure ECG:
a. Select ECG1 to the screen with waveform and adequate priority.
b. In the Parameter Setup > ECG > Setup , select ECG1 Lead: II.
2. Configure invasive pressure:
a. Select P1 to the screen with waveform and adequate priority.
b. In the Parameter Setup > Invasive Pressures > P1 , select:
−
Label: P1.
−
Scale (mmHg): 0-200 mmHg.
−
Parameter Format: Sys/Dia (Mean).
Configuring the simulator
Refer to the simulator documentation for details on how to use and configure the simulator.
1.
Configure ECG:
−
ECG rhythm: a normal sinus rhythm .
− Heart rate: 80 bpm ,
−
Amplitude: 1 mV.
2. Only for modules with invasive pressure: configure invasive pressure:
−
Sensitivity: 5 µV/V/mmHg.
−
InvBP output: “0 mmHg static pressure” or “atmosphere”.
Testing the synchronization connector
1. Test the ECG analog output signal:
a. Connect the oscilloscope probe to the ECG analog output signal (grey wire) and analog
ground (blue or white wire).
b. Adjust the oscilloscope Time and Volts scales:
c. Verify that the ECG analog output waveform shown on the oscilloscope screen
corresponds to the ECG1 waveform on the monitor screen.
2. Test the Arterial BP output signal:
NOTE: Perform this arterial BP test only if an E-PSMP, an E-PSMPW, an E-PRETN or an E-
PRESTN module is in use with the patient monitor.
a. Ensure that the simulator’s InvBP output channel is configured to 0 mmHg static pressure
or atmosphere.
ECG analog output signal: Grey
Analog GND: Blue or White
Probe Type: x10
Time/Division: 200 mS
Volts/Division: 0.5V