FujiFilm FM-DP L, Руководство по обслуживанию, Страница: 95 / 380

H3-52
006-252-02 10.22.99 FM2569
FM-DP L
Service Manual
H3-52
MAINTENANCE 3. TROUBLESHOOTING
Error code Error name Significance Probable cause and remedy
Detailed
information format
0956
Overheat 2 error
(Plate 6)
The heater (HG6) temperature is above
the currently set value (Terr) even after 6
seconds. Cooling failure.
9-A
09F1
THG1D/A conversion
error
THG1 thermistor data is abnormal.
(Detected abnormal changes in the
monitoring temperature due to noise,
etc.)
9-E
09F2
THG2D/A conversion
error
THG2 thermistor data is abnormal.
(Detected abnormal changes in the
monitoring temperature due to noise,
etc.)
9-E
09F3
THG3D/A conversion
error
THG3 thermistor data is abnormal.
(Detected abnormal changes in the
monitoring temperature due to noise,
etc.)
9-E
Malfunction of the built-in cooling fan, or built-in temperature
detection thermistor, malfunction of the heater, or SNS board.
1. Check that the connector to the heater, cable to the heater,
and connector of the power supply unit are set correctly.
2. Check the operations of the built-in cooling fan using the
M-Utility. Replace the fan if operations are faulty.
3. After cooling the equipment, check the operations of each
heater using the M-Utility. Check the temperature around
each heater with your hand, if not warm, check that the
wiring is normal, and replace the thermistor.
4. Check that the wiring between the SNS board and power
supply unit is normal, and replace the SNS board.
5. Replace the power supply unit.
Detected noise, disconnection of the I/F cable between the
SNS board and thermistor, or malfunction of the thermistor or
thermistor port of the SNS board.
1. Check that the thermistor connector, I/F cable to the
thermistor, and connector of the SNS board are set correctly
2. Replace the thermistor.
3. Replace the SNS board.
4. Replace the cable between the thermistor and SNS board.
Detected noise, disconnection of the I/F cable between the
SNS board and thermistor, or malfunction of the thermistor or
thermistor port of the SNS board.
1. Check that the thermistor connector, I/F cable to the
thermistor, and connector of the SNS board are set correctly
2. Replace the thermistor.
3. Replace the SNS board.
4. Replace the cable between the thermistor and SNS board.
Detected noise, disconnection of the I/F cable between the
SNS board and thermistor, or malfunction of the thermistor or
thermistor port of the SNS board.
1. Check that the thermistor connector, I/F cable to the
thermistor, and connector of the SNS board are set correctly
2. Replace the thermistor.
3. Replace the SNS board.
4. Replace the cable between the thermistor and SNS board.