FujiFilm FM-DP L, Руководство по обслуживанию, Страница: 119 / 380

H3-76
006-252-05 06.30.01 FM3040
FM-DP L
Service Manual
H3-76
MAINTENANCE 3. TROUBLESHOOTING
Error code Error name Significance Probable cause and remedy
Detailed
information format
2234
SE1HP deviation error
Attempted to move the transport unit
grip from the home position during
initialization, but SE1 did not become
OPEN (Retry) The following motor/sensor/part may be faulty.
Correct according to the troubleshooting procedure for this error
code in "3.1.4 Troubleshooting Flow".
SE1/ME1
2-1-C
2-2-A
2235
SE1HP return error
Attempted to move the transport unit
grip to the home position during
initialization, but SE1 did not become
CLOSE (Retry) The following motor/sensor/part may be faulty.
Correct according to the troubleshooting procedure for this error
code in "3.1.4 Troubleshooting Flow".
SE1/ME1
2-1-C
2-2-A
2238
(*1)
Sensor state 3 error
Attempted to move the sub scanning
unit grip from the home position to the
grip state during initialization in order to
detect/discharge the film(s) remaining in
the sub scanning unit, but SD2/SD3 did
not become CLOSE.
The following motor/sensor/part may be faulty. Correct
according to the troubleshooting procedure for this error code
in “3.1.4 Troubleshooting Flow”.
SD2/SD3/MD2
2-1-C
2-2-A
2239
(*1)
Sensor state 1 error
Attempted to move the sub scanning
unit grip from the grip state to the home
position during initialization in order to
detect/discharge the film(s) remaining in
the sub scanning unit, but SD2/SD3 did
not become OPEN.
The following motor/sensor/part may be faulty. Correct
according to the troubleshooting procedure for this error code
in “3.1.4 Troubleshooting Flow”.
SD2/SD3/MD2
2-1-C
2-2-A
2241
(*1)
Sensor state 3 error
Attempted to move the sub scanning
unit grip from the home position to the
grip state during initialization in order to
detect/discharge the film(s) remaining in
the before-sub-scanning conveyor, but
SD2/SD3 did not become CLOSE.
The following motor/sensor/part may be faulty. Correct
according to the troubleshooting procedure for this error code
in “3.1.4 Troubleshooting Flow”.
SD2/SD3/MD2
2-1-C
2-2-A
2242
(*1)
Sensor state 3 error
Attempted to move the sub scanning
unit grip from the grip state to the home
position during initialization in order to
detect/discharge the film(s) remaining in
the before-sub-scanning conveyor, but
SD2/SD3 did not become OPEN.
The following motor/sensor/part may be faulty. Correct
according to the troubleshooting procedure for this error code
in “3.1.4 Troubleshooting Flow”.
SD2/SD3/MD2
2-1-C
2-2-A
2249
Tray 1 film surface
detection error
Attempted to move the suction cup unit
from the upper dead-point to the
surface detection position during
removal at tray 1, but SA3 did not
become CLOSE. (Retry)
The following motor/sensor/part may be faulty.
Correct according to the troubleshooting procedure for this error
code in "3.1.4 Troubleshooting Flow".
SA3/MA1
2-1-A
2-2-A
*1: Main unit software version B01 or later.