FujiFilm FM-DP L, Руководство по обслуживанию, Страница: 105 / 380

H3-62
006-252-02 10.22.99 FM2569
FM-DP L
Service Manual
H3-62
MAINTENANCE 3. TROUBLESHOOTING
Error code Error name Significance Probable cause and remedy
Detailed
information format
1531
Maximum density data
error
Incorrect data measurement/input.
1. Re-input the 24-point data. Execute correction.
2. Check for film defects (insufficient density, etc.)
3. Check the heat development unit.
4. Check the optical unit.
5. Replace the SCN board.
None
1532
Middle density data
error
Incorrect data measurement/input.
1. Re-input the 24-point data. Execute correction.
2. Check for film defects (abnormal density, etc.)
3. Check the heat development unit.
4. Check the optical unit.
5. Replace the SCN board.
None
1533
Valid density data error
Incorrect data measurement/input.
1. Re-input the 24-point data. Execute correction.
2. Check for film defects (abnormal density, etc.)
3. Check the heat developmentunit.
4. Check the optical unit.
5. Replace the SCN board.
None
1534
Valid data difference
error
Incorrect data measurement/input.
1. Re-input the 24-point data. Execute correction.
2. Check for film defects (abnormal density, etc.)
3. Check the heat development unit.
4. Check the optical unit.
5. Replace the SCN board.
None
1535
24-point film density
gain error
Not used
·Set to 255 when the calculated results
of the 24-point density gain exceeded
the existing value.
·Set to 0 when the calculated results of
the 24-point density gain is less than
the existing value.
– None
The maximum density of the 24-point
density data was below the specified
value. (The maximum density is smaller
than the specified value 0.)
·Film defects (Insufficient density, etc.)
·Malfunction of heat development unit
·Malfunction of the optical unit
·Malfunction of the SCN board
The middle density of the 24-point
density data exceeded the specified
value. (The middle density is not within
the specified range of 0 to 400.)
·Film defects (Abnormal density, etc.)
·Malfunction of heat development unit
·Malfunction of the optical unit
·Malfunction of the SCN board
The valid data of the 24-point density
data was less than the specified number
(The valid data is smaller than the
specified value of 5.)
·Film defects (Abnormal density, etc.)
·Malfunction of heat development unit
·Malfunction of the optical unit
·Malfunction of the SCN board
The difference in the valid data of the 24
point density data is greater than the
specified value. (The valid data
difference is greater than the specified
value 200.)
·Film defects (Abnormal density, etc.)
·Malfunction of heat development unit
·Malfunction of the optical unit
·Malfunction of the SCN board