FujiFilm FM-DP L, Руководство по обслуживанию, Страница: 111 / 380

H3-68
006-252-02 10.22.99 FM2569
FM-DP L
Service Manual
H3-68
MAINTENANCE 3. TROUBLESHOOTING
Error code Error name Significance Probable cause and remedy
Detailed
information format
1604
Uniformity measurement
start disabled error
The density measurement unit is set into
the state where the uniformity
measurement is disabled. Processes other than uniformity measurement can be continued
If the image is faulty, , move to the specified position using the
M-Utility, and re-do the uniformity measurement, or reset.
6-C
160C
DSP uniformity
correction value S1
write error
Failed in writing the uniformity correction
value S1 to the DSP external memory.
Defect in the vicinity of the DSP of the IMG board.
1. Check that the CPU, IMG, input boards, MTH board related
connectors, image memory board are set to the MTH
board normally.
2. Replace the IMG board.
3. Replace the MTH board.
6-C
160D
DSP uniformity
correction value S2
write error
Failed in writing the uniformity correction
value S2 to the DSP external memory.
Defect in the vicinity of the DSP of the IMG board.
1. Check that the CPU, IMG, input boards, MTH board related
connectors, image memory board are set to the MTH
board normally.
2. Replace the IMG board.
3. Replace the MTH board.
6-C
160E
Uniformity correction
data calculation error
– – 6-C
1610
Uniformity measurement
data minimum value
error The minimum value of the uniformity
measurement data was below the
appropriate range.
Foreign particles on the measured film, film defects, or defect of
the density measurement unit.
1. Re-output the measurement pattern and measure.
2. Restart the main body.
3. Replace the optical unit.
4. Replace the density measurement unit.
6-C
1611
Uniformity measurement
data maximum error
The maximum value of the uniformity
measurement data exceeded the
appropriate range.
Foreign particles on the measured film, film defects, or defect of
the density measurement unit.
1. Re-output the measurement pattern and measure.
2. Restart the main body.
3. Replace the optical unit.
4. Replace the density measurement unit.
6-C
1A11
HD format error HD formatting failure
1. Check the HD setting.
2. Replace the HD.
None
1A12
HD setting error
Could not check the HD during the HD
READ/WRITE test.
HD not present.
1. Set to CONFIG HD is present.
2. Check HD setting.
3. Replace the HD.
None
1A13
test data compilation
error Could not create the test data during the
HD READ/WRITE test. Insufficient resources when creating the test data.
1. Expand the image memory.
None