FujiFilm FM-DP L, Руководство по обслуживанию, Страница: 121 / 380

H3-78
006-252-05 06.30.01 FM3040
FM-DP L
Service Manual
H3-78
MAINTENANCE 3. TROUBLESHOOTING
Error code Error name Significance Probable cause and remedy
Detailed
information format
2272
(*2)
Sensor state 3 error
Attempted to set the sub scanning unit
grip to the entrance/exit grip state during
recording by the sub scanning unit, but
SD2/SD3 did not become CLOSE. The following motor/sensor/part may be faulty. Correct
according to the troubleshooting procedure for this error code
in “3.1.4 Troubleshooting Flow”.
SD2/SD3/MD2
2-1-C
2-2-A
2273
(*2)
Sensor state 4 error
Attempted to set the sub scanning unit
grip to the entrance grip release state
during recording by the sub scanning
unit, but SD2 did not become OPEN
and SD3 did not become CLOSE.
The following motor/sensor/part may be faulty. Correct
according to the troubleshooting procedure for this error code
in “3.1.4 Troubleshooting Flow”.
SD2/SD3/MD2
2-1-C
2-2-A
2274
(*2)
Sensor state 1 error
Attempted to set the sub scanning unit
grip to the entrance/exit grip release
state during recording by the sub
scanning unit, but SD2/SD3 did not
become OPEN.
The following motor/sensor/part may be faulty. Correct
according to the troubleshooting procedure for this error code
in “3.1.4 Troubleshooting Flow”.
SD2/SD3/MD2
2-1-C
2-2-A
2280
Remainder check Tray
1 remainder film
present
Film was found remaining in tray 1 when
presence of remaining film was checked
during initialization.
(SA4:CLOSE)
Remove the film at the SA4 position of the upper tray. 2-1-A
2281
Remainder check
Tray 2 remainder film
present
Film was found remaining in tray 2 when
presence of remaining film was checked
during initialization.
(SB4:CLOSE)
Remove the film at the SB4 position of the lower tray. 2-1-B
2282
Remainder check
Before-sub-scanning
conveyor remainder film
present
Film was found remaining in the before-
sub-scanning conveyor when presence
of remaining film was checked during
initialization.
(SC1:CLOSE)
Remove the film at the SC1 position of the before-sub-
scanning conveyor.
2-1-A
2283
Remainder check
Transport unit
remainder film present
Film was found remaining in the
transport unit when presence of
remaining film was checked during
initialization.
(SE3:CLOSE)
Remove the film at the SE3 position of the transport unit. 2-1-C
2284
Remainder check
Heat development unit
1 remainder film
present
Film was found remaining in the density
measurement unit when presence of
remaining film was checked during
initialization.
(SG1:CLOSE)
Remove the film at the SG1 position of the density
measurement unit.
2-1-C
*2: Main unit software version B02 or later.