FujiFilm FM-DP L, Руководство по обслуживанию, Страница: 130 / 380

H3-83
006-252-05 06.30.01 FM3040
FM-DP L
Service Manual
H3-83
MAINTENANCE 3. TROUBLESHOOTING
Error code Error name Significance Probable cause and remedy
Detailed
information format
0B01
Image transfer error
(Bus controller error) An error occurred while transferring the
frame image to the print buffer The MTH board is faulty.
1. Replace the MTH board.
None
0D00
(*3)
Insufficient DRAM
memory Error detected if the DRAM option is not
added in the use of the LAN board.
None
0EEA
Image memory error
Exceeded the IM reservation range X
size
The width of the image memory is outside the specification. Or
the MTH board is faulty.
1. Replace the MTH board.
None
0EEB
Image memory error Unmatching IM capacity None
0EEC
Image memory error IM data bit length error
Malfunction of the image memory, or the image memory is for
other models.
1. Replace the image memory.
None
0F00
(*3)
Image processing
sequence error
DSP acquisition timeout None
0n00
(*3)
LAN board initialization
complete response time-
out error Generated if no response while waiting
for the initialization completed response
of the LAN board.
Malfunction of the LAN board or MTH board.
1. Check that the LAN board is connected to the MTH board
correctly.
2. Replace the LAN board.
3. If the problem persists, replace the MTH board.
None
The image memory lacks capacity.
1. Check that the image memory does not lack capacity.
2. If it does, expand the image memory. If capacity is
sufficient, reset the image memory of the MTH board
again.
3. Re-start.
4. Replace the image memory.
5. Replace the MTH board.
Expansion DRAM/CPU board defect
1. If the expansion DRAM is not mounted, mount it.
2. Check that the expansion DRAM is connected properly to
the MTH board.
(If it is not, connect it properly and start it.)
3. Replace the expansion DRAM.
4. Replace the CPU board if the error persists even after the
above.
Malfunction of the file in the memory card, memory card, or
CPU board.
1. Check that the CPU, IMG, input boards, MTH board related
connectors, and image memory board are set to the MTH
board normally.
2. Re-install the software.
3. Replace the memory card.
4. Replace the CPU board.
*3: Main unit software version B03 or later.