Fuji Xerox DocuColor 1256 GA Series, Руководство пользователя, Страница: 93 / 265

Making Copies
77
5
Erasing the Edges
(Edge Erase)
This feature allows you to erase the shadows or the marks found at the edges or the centre of the
copies made when copying bound originals.
The types of Edge Erase are listed below.
Top and Bottom Erase
Erases the top and the bottom edges of the document loaded. You can specify the width of the edge
erase within 0-50 mm in 1 mm increments.
Left and Right Erase
Erases the left and right edges of the document loaded. You can specify the width of the edge erase
within 0-50 mm in 1 mm increments.
Binding Erase
Erases the shadows found at the centre of the copies made when copying with the document cover open
or when copying bound originals. You can specify the width of the Binding Erase within 0–50 mm in 1
mm increments.
●
Multi-Up (N Up) cannot be used together with Binding Erase.
●
When Binding Erase is selected for Book Copying, the centre border will be erased based on half of the Binding Edge Erase
value.
●
The edges will not be correctly erased if the document is not loaded in the direction specified in Original Orientation. See
“5.24 Selecting the Document Orientation” for more details.
●
This feature cannot be combined with Image Repeat. Binding Erase cannot be combined with Poster.
●
If Multi-Up (N-Up) is selected together with Top and Bottom Erase or Left and Right Erase , the erase value will be applied
to the individual documents before they are copied onto one sheet.
●
When Reduce/Enlarge is selected, the edge erase value will be adjusted according to the reduce/enlarge percentage.
●
When 2-Sided is selected, the edge erase applies to both side one and side two of the document.
●
There will be an image loss of approximately 3 mm off the leading edge regardless of the edge erase value.
●
The factory default is 2 mm for Top and Bottom Erase, 2 mm for Left and Right Erase and 0 mm for Binding Erase.
●
You can change the factory default for Top and Bottom Erase and Left and Right Erase in Tools Mode. See “Chapter 6 Tools
Mode Settings” on how to change the factory defaults. You cannot change the default for Binding Erase on the Tools Mode
screen.