Fuji Xerox DocuColor 1256 GA Series, Руководство пользователя, Страница: 174 / 265

T
roubleshooting
158
7
Once a paper jam is detected, the machine will stop and an error message will be shown on the
display. Follow the instructions on the display to remove the jammed paper.
Remove the jammed paper gently to prevent tearing the paper. If the paper tears while you are
removing it from the machine, ensure that you discard all the torn pieces from the machine. If the
message persists even after you have cleared the paper, follow the instructions on the display to
check for paper jams at other locations.
After clearing all the paper jams, the message “Press Start to continue the job (Or press C button
to cancel the job)” is displayed. Press the
Start button to begin copying from where you left off
prior to the jam. Press the C button if you wish to cancel the copy job.
When removing jammed paper, make sure that no pieces of torn paper are left in the machine. A
piece of paper remaining in the machine can cause a fire.
If a sheet of paper is cannot be removed or is wrapped around the fuser or heat roller, do not try
to remove it by yourself. You may injure yourself as a result. Switch off the machine immediately
and contact your Xerox Customer Support Centre.
This section describes how to remove jammed paper from the following locations:
●
Paper tray
●
Lower left cover of the copier
●
Output tray/lower right cover of the copier
●
Inside the copier
●
Between the copier and sorter
●
Inside the sorter
●
Between the copier and finisher
●
Inside the finisher
7.2.1 Paper jam at a pap er tray
This section describes how to clear a paper jam at a paper tray.
■
Paper jam at trays 1 to 4
The following messages will be shown on the display if paper is jammed at trays 1 to 4. Remove the
jammed paper by following the steps shown.
Clearing Paper Jams