5-35
MLC 52 Series MediaLink Controller • Serial Communication
7
.
When finished entering commands for the selected button, click the Take
button in the lower-right corner of the screen to send the commands to the
MLC.
Take button on Advanced Projector Config. tab
8
.
If you want to program any additional buttons, follow steps
1
through
6
for
each button you want to configure. If you are finished programming, it is
recommended that you save these button settings as a configuration file.
(See
Saving the configuration
, earlier in this chapter.)
Creating a volume table
If a projector driver does not already exist for your projector, and the projector
requires discrete audio volume commands (for each percent of maximum volume,
for example), as opposed to a pair of volume up/down commands, you can
program those commands in the
Volume Table
section.
Use the volume table only if you plan to use the display device’s audio
inputs.
When you click the Volume Table button on the Advanced Projector Config. tab,
slider bars and buttons are displayed, by enabling you to set volume adjustment
step parameters. You can do this either by dragging the slider button right or left,
or by clicking on the right or left arrows at the ends of the slide bars.
If you select the Tools button, a pop-up menu (shown
at right) appears, giving you further options for
displaying the volume table.
Refer to your projector user manual for information
on the size and number of steps required for your projector’s volume table; or
contact the projector manufacturer.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203