Serial Communication, cont’d
MLC 52 Series MediaLink Controller • Serial Communication
5-28
The Driver Selection window is displayed on top of the Controller (MLC)
Config. tab.
4
.
On the Driver Selection window, make selections in the following list boxes:
Driver Category
— Type of product to be controlled (Video Projector, Web
TV, etc.)
Device Models
— Model name/number of your projector or other device
Functions Available in Driver
— Functions that the selected button can be
programmed to perform
Driver Selection window for IR command on IR 452
5
.
Click the Take Button Config button to implement your selections. The
command is programmed into the button’s selected memory block.
On the Driver Selection window, the radio button for the command memory
block you just programmed is surrounded by a red field (for an IR
command) or a green field (for an RS-232 command). In the following
example, an IR command was added.
Driver Selection window showing that IR 452 memory block 1
(Cmd 1) contains an IR (red) command
6
.
If you want to assign another command to the same button, select the next
Cmd radio button on the Driver Selection window, and repeat steps
4
and
5
.
For each button, you can perform this procedure up to four times, until the
button’s four memory blocks are all assigned.
For IR, you can mix driver functions from different devices on the same
button. For example, you can program a DISPLAY POWER ON button
with one command to turn on a Sanyo projector, and another command to
turn on an NEC projector. You can also add IR commands to a button on
which RS-232 commands have also been programmed, and vice versa.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203