4-9
MLC 52 Series MediaLink Controller MLC 52 • Special Applications
When a command has been successfully learned, the IR Learning LEDs on
the MLC rear panel flash in rapid progression from the top to the bottom, then
back to the top.
3
.
Program the input selection command “A” from the RGB 2 input selection
button on the projector’s remote control into memory block #2 of the
MLC 52’s PC button as follows:
a
.
Press the PC button on the MLC front panel. The button begins to blink,
indicating that the MLC is now ready to learn command “A” from the
projector remote control’s RGB 2 button. On the rear panel, the second
LED up from the bottom should be flashing.
b
.
Within 5 seconds (while the PC button on the MLC 52 is blinking), press
the RGB 2 button on the projector’s remote control. The MLC has
learned command “A” for RGB 2.
4
.
Program the input selection command “B” from the RGB 1 input selection
button on the projector’s remote control into memory block #3 of the
MLC 52’s PC
button as follows:
a
.
Press the PC button on the MLC front panel. The button begins to blink,
indicating that the MLC is now ready to learn command “B” from the
projector remote control’s RGB 1 button. On the rear panel, the third
LED up from the bottom should be flashing.
b
.
Within 5 seconds (while the PC button on the MLC 52 is blinking), press
the RGB 1 button on the projector’s remote control. The MLC has
learned command “B” for RGB 1.
5
.
Program the input selection command “B” from the RGB 2 input selection
button on the projector’s hand-held remote control into memory block #4 of
the MLC 52’s PC button as follows:
a
.
Press the PC button on the MLC front panel. The button begins to blink,
indicating that the MLC is now ready to learn command “B” from the
projector remote control’s RGB 2 button. On the rear panel, the fourth
LED up from the bottom should be flashing.
b
.
Within 5 seconds (while the PC button on the MLC 52 is blinking), press
the RGB 2 button on the projector’s remote control. The MLC has
learned command “B” for RGB 2.
6
.
If finished programming the MLC 52 buttons, return configuration
switch #1 to its Off (down) position, and test the system.
If you want to program video input selection at this time, proceed to
Programming video inputs — type A remote control
, below.
Programming video inputs — type A remote control
1.
Place the rear panel configuration switch #1 in the
on
(up) position to enter
learning mode. (If the MLC is already in learning mode, proceed to step 2.)
2
.
Using IR Learning, program command “A” from the Video input selection
button on the projector’s remote control into memory block #1 of the
MLC 52’s VIDEO button as follows:
a
.
Press the VIDEO button on the MLC front panel. The button begins to
blink, indicating that the MLC is now ready to learn command “A” from
the projector remote control’s Video button. On the rear panel, the
bottom IR Learning LED should be flashing.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203