3-9
MLC 52 Series MediaLink Controller • Operation
To program a macro on a button, follow these steps:
1
.
Ensure that power is applied to the MLC 52.
2
.
Set configuration switch #1 on the rear panel to On. All front panel buttons
light dimly.
3
.
Program the buttons with the desired commands. See
Configuring using IR
data transfer
or
Configuring using IR Learning
, earlier in this chapter, for
programming procedures.
You must program the commands onto the button prior to setting it for macro
mode.
4
.
To put the button in macro mode, press and hold it for 3 seconds. The orange
LED, labeled E on the back panel, flashes rapidly five times, then turns off,
indicating that the button is now configured for macro mode. Release the
button. The next time that the button is pressed while configuration switch #1
is in On position, the orange “E” LED lights, indicating that the button is in
macro mode.
To take a button out of macro mode, press and hold the button for 3 seconds.
The orange “E” LED turns off.
5
.
Set configuration switch #1 to Off. Verify that the commands have been
properly learned by pressing the button you programmed. The commands
should be issued in succession at 1.5-second intervals.
A button is able to learn commands while in macro mode if any of its four
command memory blocks are open (not yet programmed with a command).
Configuring a single button for input source selection
If you want to use only one button to select your input sources, you must program
the button with one command for each source (up to four). Only one button has to
learn IR commands; and it has enough memory blocks to learn four input selection
commands. To use this programmed button to select an input, you must press it
repeatedly to cycle through all the inputs until you reach the desired one.
To program a single button to select multiple inputs, follow these steps:
1
.
Disconnect power from the MLC 52.
2
.
Replace all but one of the input (VIDEO, PC, DVD, or VCR) button labels with
the provided Not Used label, or remove the input label(s) and leave the
button(s) blank.
3
.
Apply power to the MLC.
4
.
Set configuration switch #1 to On. The front panel buttons light dimly.
5
.
Press the button on the MLC 52 that will store the input selection IR codes.
The button blinks for 5 seconds, during which time it is able to learn codes.
On the rear panel, the first (bottom) Learning LED starts flashing.) (If a
command is not entered within 5 seconds, the button and LED stop blinking,
and you must press the button again to put it in back in learn mode.)
6
.
Press the IR 452 remote control button from which the MLC button will learn
the first input selection command. If the command has been learned
successfully, the Learning LEDs on the rear panel blink in rapid progression
from the top LED to the bottom, then back to the top.
7
.
To program a second input selection command on the same button, press the
button again. The button and the second rear panel Learning LED begin to
blink. On the IR 452 remote control, press the next button that you want the
MLC button to learn.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203