Special Applications, cont’d
MLC 52 Series MediaLink Controller • Special Applications
4-12
Configuring VC models — type A remote control
If you are using an MLC 52 IR VC or an MLC 52 RS VC with a type A remote,
configure the buttons as indicated in the illustration below.
1
2
3
4
5
6
7
8
0
9
VIDEO
S-Video
RGB1
RGB2
INPUTS
SET
UP
PLAY
PRG+
PRG–
POWER
REW
TV
INPUT
PAUSE
FF
STOP
DIR A
DIR B
SLEEP
TV
MUTE
TIME/
LEVEL–
DLY/CNT/REAR
TIME/
LEVEL+
UP
LEFT
RIGHT
DOWN
SKIP/CHAPTER
+100
–
+
DECK
A/B
EFFECT
ON/OFF
REC/
PAUSE
INPUT SELECT
CD
TAPE
TUNER
PHONO
TV/DBS
TEST
DVD/LD
VCR
ENT
DISP
Projector Remote Type A
MLC 52
DISPLAY
ON
PC
OFF
DVD
VCR
VOLUME
Command #1: RGB 1 IR Command “A”
Command #2: RGB 1 IR Command “B”
Optional:
Command #1: RGB 2 IR Command “A”
Command #2: RGB 2 IR Command “B”
Label button accordingly and place it in
“group”.
Command #1: S-video 2 IR Command “A”
Command #2: S-video 2 IR Command “B”
Command #1: Video 1 IR Command “A”
Command #2: Video 1 IR Command “B”
Configuring an MLC 52 VC model with a type A projector remote
control
Projector remote control type B (application 3)
This remote control has only two input buttons—one for the RGB inputs and one
for the S-video and composite video inputs. Each of these buttons contains two
commands (commands “A” and “B”) that cause the button to toggle between
inputs.
Following these steps, use IR Learning to program the input selection commands
from the projector’s type B hand-held remote control onto the MLC’s PC and
VIDEO or blank (VC models) buttons.
Programming RGB inputs — type B remote control
1.
Place the rear panel configuration switch #1 in the On (up) position to enter
learning mode.
2
.
Using IR Learning, program command “A” from the RGB input selection
button on the projector’s remote control into memory block #1 of the
MLC 52’s PC button as follows:
a
.
Press the PC button on the MLC front panel. The button begins to blink,
indicating that the MLC is now ready to learn command “A” from the
projector remote control’s RGB button. On the rear panel, the bottom
IR Learning LED should be flashing.
b
.
Within 5 seconds (while the PC button on the MLC 52 is blinking), press
the RGB button on the projector’s remote control. The MLC has learned
command “A” for RGB.
When a command has been successfully learned, the IR Learning LEDs on
the MLC rear panel flash in rapid progression from the top to the bottom, then
back to the top.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203