Exabyte 221L, Руководство по эксплуатации продукта

Страница: 177 / 208

A
UGUST
2005 E
XABYTE
221L
AND
221L-FC L
IBRARIES 161
E
RROR
C
ODES
140 Flash erase fail. The library is
unable to erase the flash
EEPROM.
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If the error persists, contact your service provider.
141 Flash program fail. The library is
unable to program the flash
EEPROM.
142 Checksum miscompare. The
flash EEPROM checksum was
bad.
143 Invalid header data. The flash
EEPROM header was invalid.
144 Can’t program RRC card. The
RRC code load failed.
ƒ
Reset the library (see page 66 ).
ƒ
If the error persists, contact your service provider.
194 All slots are full. The robot could
not find an empty cartridge slot.
ƒ
Open the door and remove at least one cartridge from a
magazine or fixed slot.
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If the error persists, contact your service provider.
195 All slots are empty. The robot
could not find a cartridge to pick
in Demo mode.
Open the door and insert at least one cartridge in a magazine.
198 Robot full before command. The
robot, all slots, and all drives
contain a cartridge when an
Initialize Element Status
command was requested.
ƒ
Open the door and remove the cartridge from the robot
gripper.
ƒ
Reset the library (see page 66 ).
199 Tape in drive. A cartridge is
already loaded in the destination
tape drive.
Eject the cartridge from the tape drive and remove it manually
(see page 67 ).
Note: This error only occurs when the library is operating in
sequential mode.
200 X axis does not move. The robot
could not move along the
horizontal axis.
ƒ
Open the door and remove the magazines. Look for
anything that might be obstructing the robot’s path along
the horizontal axis.
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If there are no obstructions and the error persists, contact
your service provider.
201 X axis has failed home. The
robot could not return to the
home position along the
horizontal axis.
202 X axis position sensor failed.
The library could not complete a
move along the horizontal axis.
Table 8-1 Library error codes (continued)
Code Description Corrective Action