Exabyte 221L, Руководство по эксплуатации продукта

Страница: 141 / 208

A
UGUST
2005 E
XABYTE
221L
AND
221L-FC L
IBRARIES 125
I
SSUING
L
IBRARY AND
T
APE
D
RIVE
C
OMMANDS
3.
3. 3.
3. Click on Run the library in demo mode. A page similar to Figure 6-36
appears.
4. 4. 4. 4. Enter the number of cycles for the demo.
5. 5. 5. 5. If you want the tape drive(s) used in the demo, check the Use tape drives in
demo box.
6.
6. 6.
6. If you want tapes loaded into the tape drive(s), check the Load tape drives
during demo box. Specify how often you want tapes loaded in the drive(s)
in the Drive Frequency box.
7.
7. 7.
7. If you want cartridge inventories performed during the demo, check the
Perform IES during demo box. (IES is Initialize Element Status, the SCSI
command that performs a cartridge inventory.) Specify how often you
want a cartridge inventory performed in the IES frequency box.
8. 8. 8. 8. Click on the Start Demo button.
Note: If you want to stop a demo in progress, click on the Stop button.
9. 9. 9. 9. When the demo is finished, return the library to its original control mode.
I
SSUING
L
IBRARY
C
OMMANDS
You can issue the following library commands:
Self test – Runs the library’s self test. During the self test, the robot moves to
Drive 1, rotates 180 degrees, moves to slot 1, rotates 180 degrees, then
returns to Drive 1.
Position to element – Moves the robot to a position you specify (in front of
a tape drive, fixed cartridge slot, magazine slot, or the entry/exit port).
Figure 6-36 Remote management utility – Demo Mode page