Exabyte 221L, Руководство по эксплуатации продукта

Страница: 178 / 208

162
P
RODUCT
M
ANUAL
1014258
C
HAPTER
8—T
ROUBLESHOOTING AND
E
RROR
C
ODES
203 X axis EOT fail. The library could
not detect the end-of-travel
sensor on the horizontal axis.
ƒ
Open the door and remove the magazines. Look for
anything that might be obstructing the robot’s path along
the horizontal axis.
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If there are no obstructions and the error persists, contact
your service provider.
204 X axis home sensor fail. The
library could not detect the
horizontal axis home sensor (safe
rotate position).
205 X axis scan failed. The library
could not complete a move along
the horizontal axis.
207 X axis cal fail. The robot position
along the horizontal axis could
not be calibrated.
213 Invalid Xcard configuration. An
invalid combination of expansion
cards is installed in the library.
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If the error persists, contact your service provider. An
expansion card may not be properly installed or the wrong
card is installed.
214 Invalid Slot Config. The
Maximum Number of Slots is set
to 1 and the last slot is configured
as a cleaning slot.
Change the Max Addressable Slot to a value greater than 1
(see page 48 ) or turn off the Clean Slot Option (see page 44 ).
220 OS failure. The library’s
operating system experienced an
error.
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If the error persists, contact your service provider.
221 Could not set alarm. The
library’s operating system
experienced an error.
222 OS message failure. The library’s
operating system experienced an
error.
226 Mbus interrupt timeout. The
robot command processor timed
out before setting an interrupt.
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If the error persists, the robot may need to be replaced.
Contact your service provider.
227 Mbus acknowledge failure. The
robot command processor failed
to respond to a command.
230 DHCP server timeout. The
Ethernet DHCP server could not
assign an IP address for the library.
Set the network address to Static and set the desired IP address
(see page 38 ).
Table 8-1 Library error codes (continued)
Code Description Corrective Action