Exabyte 221L, Руководство по эксплуатации продукта

Страница: 165 / 208

A
UGUST
2005 E
XABYTE
221L
AND
221L-FC L
IBRARIES 149
U
PGRADING
L
IBRARY
F
IRMWARE AND
C
REATING
D
IAGNOSTIC
L
ISTINGS
C
ONNECTING TO THE
L
IBRARY
’
S
FTP I
NTERFACE
This section describes how to connect your library to a host computer and use
an FTP utility to upgrade library firmware or create a diagnostic listing.
To use an FTP utility with the library, you must have the following:
A Category 5 (100BaseT connection) data-grade cable
Software that supports RFC 959 file transfer protocol
A host computer or network connection that uses a pin-through-hole RJ-45
shielded Ethernet connector
To access the library’s FTP interface:
1.
1. 1.
1. Connect the Ethernet cable as described on page 22 , and set Ethernet
configuration options as described on page 38 . Make a note of the library’s
IP address.
2.
2. 2.
2. From your host computer, activate the FTP utility you are going to use.
Connect to the library using the library’s current IP address.
3. 3. 3. 3. Log into the library’s FTP interface using the FTP user name and password
you set during library configuration (see page 41 ). If you did not set an FTP
user name and password for the library, use the defaults:
User name: anonymous
Password: Exabyte
Note: The user name and password are case-sensitive.
Figure 7-8 Console Configuration Information screen