Exabyte 221L, Руководство по эксплуатации продукта

Страница: 174 / 208

158
P
RODUCT
M
ANUAL
1014258
C
HAPTER
8—T
ROUBLESHOOTING AND
E
RROR
C
ODES
36 RRC command reject. An invalid
command was sent to the robot
command processor.
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If the error persists, the robot may need to be replaced.
Contact your service provider.
38 Cannot load drive. The robot
cannot load the cartridge into the
tape drive.
ƒ
Open the door and remove the magazines. Look for
anything that might be obstructing the robot along its reach
axis.
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If the error persists, contact your service provider.
41 W axis failed home. The library
could not move the robot to the
home position on the wrist axis.
ƒ
Open the door and remove the magazines. Look for
anything that might be obstructing the wrist axis rotation.
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If the error persists, contact your service provider.
42 Wrist front sensor failed. The
library could not determine the
position of the robot on the wrist
axis.
43 Wrist back sensor failed. The
library could not determine the
position of the robot on the wrist
axis.
60 No label. The bar code scanner
could not read the bar code label
because there was no label on the
cartridge or the label was
unreadable.
This error appears on the Label Information screen.
ƒ
If the cartridge has a label, reposition or replace it (see
page 14 ).
ƒ
If the label does not contain a checksum character, make
sure the Verify Barcode Checksums option is off (see
page 47 ).
ƒ
If the error persists, contact your service provider.
62 Not present. The bar code
scanner could not read the bar
code label because the
designated element is not
present.
This error appears on the Label Information screen.
If necessary, install a magazine or tape drive.
64 Bad label checksum. The bar
code scanner could not read the
label because of a problem with
the checksum character.
This error appears on the Label Information screen.
ƒ
If the label does not contain a checksum character, make
sure the Verify Barcode Checksums option is off (see
page 47 ).
ƒ
Check the label for damage and replace the label if
necessary (see page 14 ).
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If the error persists, contact your service provider.
Table 8-1 Library error codes (continued)
Code Description Corrective Action