Exabyte 221L, Руководство по эксплуатации продукта

Страница: 40 / 208

24
P
RODUCT
M
ANUAL
1014258
C
HAPTER
2—I
NSTALLING THE
L
IBRARY
P
OWERING
O
N THE
L
IBRARY
To power on the library:
1.
1. 1.
1. Make sure that the power switch on the back of the library, shown in
Figure 2-16 , is off (the
0
is pressed).
2.
2. 2.
2. Connect the female end of the power cord to the power connector on the
back of the library.
3.
3. 3.
3. Plug the male end of the power cord into the power source.
Note: The library has autoranging voltage selection, so you do not need to
change the voltage setting.
4. 4. 4. 4. Make sure the library’s door is closed.
5. 5. 5. 5. Push the power switch on the back of the library to the on position (the
I
is
pressed). The library performs its power-on sequence. During this time, the
cooling fans begin to operate, the LCD illuminates, and the tape drive(s)
and library perform power-on self-tests.
Figure 2-16 Location of library’s power connector and power switch
Power
switch
Power
connector
!
! !
!
Important
Two power cords are shipped with the library: One for use in the
US and Canada, and one for use in Europe. Use the correct power
cord for your location. See page 173 for power cord requirements
for other locations.