Exabyte 221L, Руководство по эксплуатации продукта

Страница: 173 / 208

A
UGUST
2005 E
XABYTE
221L
AND
221L-FC L
IBRARIES 157
E
RROR
C
ODES
13 Put failure. The robot could not
place a cartridge because of
mechanical problems.
ƒ
Open the door and remove the magazines. Make sure there
is nothing blocking the robot or the tape drive(s).
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If the error persists, the robot may need to be replaced.
Contact your service provider.
14 Pick failure. The robot could not
pick a cartridge because of
mechanical problems.
15 No source element. No
magazine was installed at the
selected location.
ƒ
Install a magazine or redirect the robot.
ƒ
If a magazine is already installed when either of these error
codes displays, reset the library (see page 66 ).
ƒ
If the error persists, contact your service provider.
16 No destination element. No
magazine was installed at the
selected location.
18 Source inside drive. The robot
could not successfully pick a
cartridge because it was still
loaded in the tape drive.
ƒ
Open the door and manually eject the cartridge from the
tape drive (see page 67 ). Or, redirect the robot to another
source location.
ƒ
If the error persists, contact your service provider.
30 R axis does not move. The robot
could not move along the reach
axis.
ƒ
Open the door and remove the magazines. Look for
anything that might be obstructing the gripper or the robot’s
path along the reach axis.
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If there are no obstructions and the error persists, the robot
may need to be replaced. Contact your service provider.
32 Barcode module failure. The bar
code module is not functioning
properly.
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If the error persists, the bar code module may need to be
replaced. You may need to supply a diagnostic listing; you
may need new firmware. Contact your service provider.
34 RRC sensor failure. The robot
gripper sensor failed.
ƒ
Open the door and remove the magazines. Look for
anything that might be obstructing the gripper or the robot’s
path along the reach axis.
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If there are no obstructions and the error persists, the robot
may need to be replaced. Contact your service provider.
35 RRC communication failure. The
library cannot communicate with
the robot gripper command
processor.
ƒ
Make sure the library and tape drive(s) are not being used
by any host, then reset the library (see page 66 ).
ƒ
If the error persists, the robot may need to be replaced.
Contact your service provider.
Table 8-1 Library error codes (continued)
Code Description Corrective Action