eta 0038/00, Инструкция по эксплуатации

Страница: 82 / 192

GrindingandAdjustingtheGrinder:
Toachievefineconsistency,werecommendgrindingmaterialsintwopasses.ONLY
well-driedwheatcanbegroundinonepass.
SettingtheCoarsenessofGrinding:
In relation to the required level of grinding or used material, set the distance of the grinding
stones using the regulating disc Q5 so that you can achieve the required coarseness of
grinding.
Turning the disc clockwise (i.e. to the right) increases the fineness of grinding, turning the
disc counter clockwise (i.e. to the left) increases the coarseness of grinding.
To release the regulating disc easily Q5 , use the release key Q9 .
Specification: The following terms are used for manipulation with the regulating disc Q5 :
-arrestingposition,
-turn,
-click.
All the terms express the same activity which is changing the setting of the regulating disc
by one position. The change is accompanied by corresponding sound.
1)InitialPosition:
Tighten the grinding stones together by turning the regulating disc Q5 clockwise (i.e. to
the right) on the assembled and cleaned grinder. Use three fingers for tightening. Never
tightenthestoneswiththeforceofyourfirmlyclosedhand!
2)Firstpass:
This setting means releasing the regulating disc Q5 which creates a gap between the
grinding stones for FIRST COARSE GRINDING. When turned by over 15 positions we
recommend that you place the ingredient in the grinder and switch on the food-processor
for 10 seconds so that you can continue in loosening the knob, accompanied by a click
sound. The range should move from 6 to 30 turns.
3)SecondPass
When the first pass is completed, tighten the regulating disc
Q5
(count the number of
clicks) to the required setting according to the processed material, see Chapter Grinding
Individual Materials. Proceed in the same way as in the first pass.
BeforeFirstUse
Turn the regulating disc Q5 using three fingers clockwise (i.e. to the right) to tighten the
grinding stones, i.e. to the initial position. Plug the power cord in the electric socket. Turn
the appliance on at the maximum speed for about 15 seconds, then turn the drive unit off,
which grinds the stones. Now, turn the regulating disc by 10 arresting positions (clicks)
back to loosen the grinding stones. Place a stainless bowl or another suitable vessel under
the grinder to collect the milled flour. Pour about 150 g of regular rice in the hopper Q6
and turn the appliance on at maximum speed. Grind the rice and stop the appliance. Then,
tighten the regulating disc by 4 positions (i.e. 6 turns).
Donotdisassembleandcleanthegrinderbetweentheindividualsettings.
Mix the ground rice and pour it into the hopper again. Grind the rice in the second pass. Then
turn the regulating disc by 3 positions (i.e. 3 turns). Mix the ground rice again and pour it into
the hopper again. Grind the rice in the third pass. Remove the grinder Q from the drive unit and
dismantle it. Disassemble both the stones and clean them thoroughly with the brush provided.
82
GB
/ 184