eta 0038/00, Инструкция по эксплуатации

Страница: 91 / 192

NeversoakgrindingstonesQ2,Q4inwaterandneveruse
awetbrushtocleantheirsurface!Also,donotuseanysteelor
othermetalbrushers,steelwooletc.tocleanthestones!
Procedureforreplacingstones
(Fig. 16)
Disassemble the grinder. Using a suitable tool (such as a screwdriver), release the cover
Q1
by gradually inserting a screwdriver into the 4 pcs screws
Q8
unscrew from the body
Q0 of the grinder. You can now easily remove the cover Q1 . Remove (knock out) the fixed
grinding stone
Q2
from the body of the grinder
Q0
. Replace the stone with a new one
ETA 002800960 . Them and thus reduce their efficiency.
Attention:Makesurethatthecutcreatedinthegrindingstoneprecisely“fits”the
createdprotrusiononthebodyofthegrinder.
If the distance ring
Q3
and seal
Q7
are worn out or damaged, replace it with a new one
(the same type ETA 0028000920, ETA 002800905).
Replace the assembled rotating grinding stone
Q4
with a new one (the same type
ETA 0028000940). When assembling the stones, proceed in the opposite order.
4)
Attachmentforice-cream
R
Immediately after use, wash the attachments in hot water with a detergent and let dry out.
Sealingreplacementprocedure
Proceed according to Fig. 19. If sealing R2 is worn out or damaged, replace it with a new
one (of a similar type ETA 002800974).
5)Foodschopper S
Immediately after use, wash the attachments (not be washed sickle-shaped knife
S3
)
in hot water with a detergent and let dry out (you can also wash the container S1 in
a dishwasher). Clean knife
S3
with a soft and wet cloth with a little detergent or knife
cleaning procedure: pour about 80 ml of clear water in the container, switch on the
appliance and remove the impurities by several pulses.
Sealingreplacementprocedure
Proceed according to Fig. 21. If sealing S4 is worn out or damaged, replace it with a new
one (of a similar type ETA 002800985).
6)
Knifesharpener
T
If you wish to remove the dust that is produced during the sharpening operation and which
gathers inside the sharpener. The appliance shake it to remove the dust that may be
present around the opening.
VI. ENVIRONMENT
If the dimensions allow, there are marks of materials used for production of packing,
components and accessories as well as their recycling on all parts. The symbols specified
on the product or in the accompanying documentation mean that the used electrical or
electronic products must not be disposed of together with municipal waste. For proper
disposal, hand them over at the special collection places where they will be accepted free
of charge. Suitable disposal of the product can help to maintain valuable natural resources
and to prevent possible negative impacts on the environment and human health, which
could be the possible consequences of improper waste disposal.
GB
91 / 184