Commissioning
Proline Promag 53 PROFIBUS DP/PA
100
Hauser
6.3.5
Data back-up with “T-DAT SAVE/LOAD”
!
Note!
This function is only available if the T-DAT memory module is installed in the corresponding slot of
the amplifier board.
The “T-DAT SAVE/LOAD” function can be used to store all the settings and parameters of the
device to the T-DAT data storage device. Since the T-DAT module can be plugged into other
devices, it is possible to transfer settings and parameters selected for the transmitter to other devices.
a0001221-en
Fig. 61:
Data back-up with “T-DAT SAVE/LOAD” function
Options
LOAD
Data on the T-DAT data storage device are copied to the device memory (EEPROM).
This overwrites any settings and parameters of the device.
The measuring device is restarted.
SAVE
The settings and parameters are copied from the device memory (EEPROM) to the T-DAT.
CANCEL
Cancels the option selection and returns you to the higher selection level.
!
Note!
• The LOAD function is only possible if the target device has the same software version as, or a more
recent software version than, the source device. If the target device has an older software version,
the message “TRANSM. SW-DAT” is displayed during startup. Then only the SAVE function is
available.
• The SAVE function is always available.
Application examples
• After commissioning, the current measuring point parameters can be saved to the T-DAT as a
backup.
• If the transmitter is replaced for some reason, the data from the T-DAT can be loaded into the
device memory of the new transmitter (EEPROM).
+
+
E
+
E
B
QUICK SETUP
1009
HOME-POSITION
Esc
E
+
-
XXX.XXX.XX
T-DAT
SAVE/LOAD
SAVE
LOAD
CANCEL
YES
NO
Sure?
YES
NO
Sure?
Input
is saved
Restart
of the
measuring device
