Endress+Hauser Deltabar S FMD77, Руководство по эксплуатации

Страница: 99 / 114

Deltabar S FMD77, FMD78, PMD75 with FOUNDATION Fieldbus Diagnostics and troubleshooting
Hauser 99
9.5 Overview of diagnostic events
9.5.1 Failure (F)
Diagnostic
Code Error
response Message/description XD_
ERROR
Value Bit
BLOCK_
ERROR
Value Bit
Cause Measure Prio-
rity
101 Alarm F>Sensor electronic
EEPROM error
20 0 – Electromagnetic effects are
greater than specifications in
the technical data.
(
 See Section 10.) This
message normally only
appears briefly.
– Wait a few minutes.
– Restart the device. Perform
reset (Code 62).
– Block off electromagnetic
effects or eliminate source of
disturbance.
19
– Sensor defect. – Replace sensor.
110 Alarm F>Checksum error in
EEPROM:
configuration segment
23 0 – The supply voltage is
disconnected when writing.
– Reestablish supply voltage.
Perform reset if necessary
(code 7864) and recalibrate
the device.
6
– Electromagnetic effects are
greater than specifications in
the technical data.
(
 See Section 10.)
– Block off electromagnetic
effects or eliminate sources of
disturbance.
– Main electronics defect. – Replace main electronics.
113 Alarm F>ROM failure in
transmitter electronic 20 0 – Main electronics defect. – Replace main electronics. 1
121 Alarm F>Checksum error in
factory segment of
EEPROM 23 0 – Main electronics defect. – Replace main electronics. 5
122 Alarm F>Sensor not
connected
20 7 – Cable connection sensor –
main electronics
disconnected.
– Check cable connection and
repair if necessary.
14
– Electromagnetic effects are
greater than specifications in
the technical data.
(  See Section 10.)
– Block off electromagnetic
effects or eliminate source of
disturbance.
– Main electronics defect. – Replace main electronics.
– Sensor defect. – Replace sensor.
130 Alarm F>EEPROM is defect. 23 0 – Main electronics defect. – Replace main electronics. 11
131 Alarm F>Checksum error in
EEPROM: min/max
segment
23 0 – Main electronics defect. – Replace main electronics. 9
132 Alarm F>Checksum error in
totalizer EEPROM
23 0 – Main electronics defect. – Replace main electronics. 7
133 Alarm F>Checksum error in
History EEPROM 23 0 – An error occurred when
writing.
– Perform reset (code 7864)
and recalibrate the device.
8
– Main electronics defect. – Replace main electronics.
135 Alarm F>Checksum error in
EEPROM FF segment 23 0 – Main electronics defect. – Replace main electronics. 10
703 Alarm F>Measurement error 20 0 – Fault in the main electronics. – Briefly disconnect device from
the power supply.
24
– Main electronics defect. – Replace main electronics.
705 Alarm F>Measurement error 20 0 – Fault in the main electronics. – Briefly disconnect device from
the power supply.
23
– Main electronics defect. – Replace main electronics.