Endress+Hauser Deltabar S FMD77, Руководство по эксплуатации

Страница: 83 / 114

Deltabar S FMD77, FMD78, PMD75 with FOUNDATION Fieldbus Commissioning
Hauser 83
Factory setting of assignment parameters
Proceed as follows to change the diagnostic behavior of an event group:
1. Open the assignment parameter to which the group is currently assigned.
2. Change the bit of the event group from
1 to 0 . If using FieldCare, this is done via the
FF912 module by disabling the appropriate check box (see the following example).
3. Open the assignment parameter to which the group should be assigned.
4. Change the bit of the event group from
0 to 1 . If using FieldCare, this is done via by
enabling the appropriate check box (see the following example).
Example
The Highest Severity / Electronics group contains the events 131: Checksum error in
EEPROM: min/max segment, among others. These should no longer be categorized as
Failure (F) , and should be categorized as Check (C) instead.
1. In the FieldCare navigation window navigate to Expert  Field Device Diagnostic 
Configuration
Standard area Configurable area
Event severity Highest severity High severity Low severity Lowest severity
Event source
1)
S E C P S E C P S E C P S E C P
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15...1
FD_FAIL_MAP 1 1 1 1 0 0 0 0 0 0 0 0 0 0 0 0 0
FD_CHECK_MAP 0 0 0 0 1 1 1 1 0 0 0 0 0 0 0 0 0
FD_OFFSPEC_MAP 0 0 0 0 0 0 0 0 1 1 1 1 0 0 0 0 0
FD_MAINT_MAP 0 0 0 0 0 0 0 0 0 0 0 0 1 1 1 1 0
1) S: Sensor; E: Electronics; C: Configuration; P: Process