14.01.2019
11/185
2 Safety instructions
•
This operating manual is part of the equipment. It
must
be kept in the vicinity of the controller as well as
for future use so that it can be consulted when required. The operating manual must be available for the
operating and maintenance personnel
at any time
for the avoidance of operating errors, see chapter
Erklärung zu den 'Sicherheits- und Gefahrenhinweisen'
.
•
For safety reasons, the equipment must not be used for any applications other than described in the
operating manual and only for the intended use, see chapter
Warning Signs and Symbols Used
•
Before using the device, check whether it is suitable for your application with regard to its limit values.
•
Before connecting the device, it must be checked whether the power supply is suitable for the device.
•
When using uncoded plug connectors, it is possible to connect them so that there is a danger to life and
limb! If this cannot be ruled out, coded plug connectors must be used.
•
Specified environmental conditions (e.g. humidity and temperature limits) must be observed and
complied with. Otherwise, malfunctions are possible (see chapter
Technische Daten VS 3010 C / SIOX
).
•
Before switching on the device, check correct wiring of the connections.
•
The device must never be operated without its case. Before opening the case, the device must be
disconnected from the power supply.
•
Note the maximum load of the relay contacts (see chapter
Technische Daten VS 3010 C / SIOX
•
Contact the supplier in the case of any malfunction.
The safety regulations, instructions and information described in this chapter must be strictly observed
and complied with. During repairs on the entire E*LDS system, the accident prevention regulations and
general safety regulations must be strictly complied with. Important information (safety instructions and
hazard warnings) are indicated by appropriate symbols (see the chapter
). Follow these
instructions in order to prevent accidents and danger to life and limb, as well as damage to the E*LDS
system.
Warning of dangerous electrical voltage! Danger of electric shock!
Beware of external voltage at
the digital inputs and outputs! All device connections/male connectors must only be plugged in,
unplugged and/or wired when
no voltage is present
.
1. According to experience, transmission of alarms is not yet functional during commissioning (no
telephone line laid etc.). It is strongly recommended in such cases to monitor the controller via
the CAN bus using a system centre or an operator terminal and to enable transmission of alarms
using a GSM modem via a mobile telephone system. In standalone operation, or as an
alternative to monitoring with system centre / operator terminal, an available alarm contact on
the controller must be used to realise transmission of alarms via a telephone network.
2. After the setting up of transmission of alarms or alarm signalling, this must be tested and
checked for its function.
For further information about the CAN bus, see the operating instruction "Basic and General Safety and
Connection Notes".
Содержание VS 3015 C
Страница 8: ...14 01 2019 8 185...
Страница 46: ...14 01 2019 46 185...
