Doosan P185WDOU-T4F (F89), Руководство по эксплуатации и обслуживанию

Страница: 105 / 196

Engine Operation
Refer to the Preventive Maintenance Schedule in this manual for recommended servicing
intervals. Perform the following procedure below as follows:
Adding oil which exceeds the upper limit of the oil level gauge may
cause engine faults. If you have injected engine oil far over the upper
limit of the oil level gauge, drain it until the engine oil level indicates
somewhere between the upper and lower limit of the oil level gauge.
Procedure:
1. Locate the oil filter. If the old and new oil filters are not the same, double-check the
application to be sure you have the correct filter. (Refer to engine owner’s manual for
additional information.)
2. Position an oil catch pan under oil filter to catch any residual oil remaining inside filter.
3. Loosen the oil filter or oil filter cap with oil filter wrench, and allow the oil to drain
from the oil filter (See Figure 4-5).
4. Remove the oil filter. Check to make sure the filter gasket has come off with the filter.
If it's still clinging to the engine mounting plate, remove it and any remaining residue.
Install:
1. Cleanly wipe the surface on which the oil filter is mounted. (See Figure 4-5).
2. Place a light coating of new oil on the gasket of the new oil filter (See Figure 4-5) so it
will install smoothly onto the engine. (Note: Do not use grease!) By hand, install the
new oil filter onto the engine by turning in a clockwise direction. Once the oil filter
gasket first contacts the mounting plate gasket surface, tighten the filter, preferably by
hand. Generally, this is three-quarters to one full turn after the filter gasket contacts
the engine. (NOTE: Cartridge oil filter replacement procedures may differ. Refer to
engine owner’s manual for instructions.)
3. Assemble the oil filter with the filter wrench at a torque of 16 ~ 20 Nm.
4. Add the engine oil.
Inject genuine oil recommended by Doosan.
5. Reinsert the oil level gauge (dipstick).
6. Reinstall the oil cap.
7. Remove the engine oil drain container from under the drain valve.
105