Dion-Ag F41, Руководство оператора, Страница: 59 / 176

59
ASSEMBLING INSTRUCTIONS - DRAW BAR EXTENSION
Follow these instructions to install a cat. III and IV
draw bar extension:
1. Insert shims (items 1 and 2) inside extension (item
3). Insert extension with shim inside the draw bar
(item 4). You need at least the thickness of one shim
(item 2) to clear the bolt head.
2. Insert two stove bolts (item 6) through the shims
as shown below. Insert bolts (item 6) inside the ex-
tension (item 3) and screw the nuts (item 8) on the
stove bolts (item 6). Adjust the shims to eliminate
the clearance between the extension and the trac-
tor’s draw bar, from top to bottom.
3. Insert pin (item 9) with a safety pin (item 10) inside
extension (item 3) and lock with safety pin (item 10).
If the hole in the draw bar is too large, insert a bush-
ing (item 13) in the hole to reduce the clearance with
the pin (item 9).
4. Screw nuts (item 12) on bolts (item 11) and then
screw bolts (item 11) on both sides of extension
(item 3) as shown below.
5. Center the extension (item 3) with the draw bar (item
4). To center side to side, use the bolts (item 11)
then lock in place with the nuts (item 12).
6. Insert pin (item 14) and lock with the safety pin (item
15). Note that items 14 and 15 are not supplied by
the manufacturer.
7. Install the safety chain (item 16) between the trac-
tor frame and the Forage Harvester. Refer to page
76 for more information on how to install the safety
chain.
A
A
A
1
6
11
12
12
11
3
4
13
2
15
10
5
4
3
6
8
8
6 1
2
12
12
11
11
9
A
16
14
Figure 72 Cat. III and IV draw bar extension
Manual No . F4117E987E V1.1