Delta Ultron DPM Series, Руководство пользователя

Страница: 111 / 264

5 - 2 3
5 Installation and Wiring
6LQJOH,QSXW'XDO,QSXW0RGL¿FDWLRQ
WARNING: Only authorized Delta engineers or service personnel can modify
single input/ dual input setup.
NOTE:
For 1000kW UPS and 1250kW UPS, their single input/ dual input modification
methods are the same and only their UPS system cabinets rather than power
PRGXOHVQHHGWREHPRGL¿HG
The UPS default setting is single input. If you want to modify it into dual input, please follow
the following steps.
1
Open the UPS system cabinet’s two front doors. After that, you will see the wiring
terminals at your left-hand side. See Figure 5-19 .
1000/ 1250kW
Don’t o perate
unless in
emerg
ency!
EMERG ENCY POWE
R OFF
OUTPUT BREAKER
INPUT BREAKER
BYPASS BREAKER
BATTERY FUSE
BATTERY BREAKER OUTPUT DRY CONTACT INPUT DRY CONTACT REPO EXTERNAL BATT. TEMP. DETECTION
MANUAL BYPASS BREAKER
COM COM NO NC OD2 OD2 OD4 OD4 OD6 OD6 ID2 G2 B2 NO NC NC COM COM NO NC COM G2 G4 B4
COM COM NO NC OD1 OD1 OD3 OD3 OD5 OD5 ID1 G1 B1 NO NO NO NC NC COM COM COM G1 G3 B3
EPO
SMART SLOT
RS-232
PM
SYS
PM SYS
PARALLEL
EXTERNAL BREAKER DETECTION
PARALLEL
SWITCH
BATT. START REPO
OUTPUT/INPUT
DRY CONTACT
DISPLAY
EXTERNAL BATT.
TEMPERATURE DETECTION
(Front View of the UPS System Cabinet with Two Front Doors Open)
Open the Two Front Doors
1
Find the Wiring Terminals
2
(Figure 5-19: UPS System Cabinet’s Front View with Two Front Doors Open)