Delta Ultron DPM Series, Руководство пользователя

Страница: 84 / 264

4 - 1 8
Ultron DPM series
ID1 G1
ID2 G2
VCC
GND
n = 1, 2
IDn Gn
Default: Generator's Power Supply Signal
Default: N/A
(Figure 4-26: Input Dry Contacts_ Pins
’
Location and Wiring Diagram)
If you want to detect the external battery cabinet’s charging protection, please use the
LCD to log in as an
Administrator . For the Administrator password, please contact
service personnel. After you log in as an Administrator , tap the Main Menu icon
located in the lower left corner of the LCD and select UPS Setup
ĺ
Battery Setting
to enable ' Battery Charging Protection (IP DRY 2) '. Please follow
1
~
5
shown in
Figure 4-27 to complete the set-up procedures mentioned above. After that, connect
the external battery cabinet’s signal cable to the input dry contacts (
ID2 G2
). When the
UPS receives relevant signal, the UPS will stop charging the batteries.
Standby
UPS-0.1
2019-Mar-01 09:30
UPS Setup Battery Setting
Battery Cut Off Voltage
Install Date
Next Replace Date
Battery Charging
Protection (IP DRY 2)
EVENT LOG
V
(380~441)
420
2019-Mar-01
2021-Mar-01
Battery Fault Alarm (IP
DRY 1)
Enable
Disable
Baseline build for Aging Reference
1
2
3 4
5
(Figure 4-27: Battery Charging Protection (IP DRY 2) Setup)
If you want to detect the external battery cabinet’s fault alarm, please use the LCD to
log in as an
Administrator . For the Administrator password, please contact service
personnel. After you log in as an Administrator , tap the Main Menu icon located in
the lower left corner of the LCD and select UPS Setup
ĺ
Battery Setting to enable
' Battery Fault Alarm (IP DRY 1) '. Please follow
1
~
5
shown in Figure 4-28 to
complete the set-up procedures mentioned above. After that, connect the external
battery cabinet’s signal cable to the input dry contacts (
ID1 G1
). When the UPS
receives relevant signal, the UPS will initiate an alarm.