[21]
Thermal warning
The thermal warning turns on when the temperature exceeds the limit in motor, drive, or ther-
mistor.
[22]
Ready, no thermal
warning
The drive is ready for operation and no thermal warning is present.
[23]
Remote, ready, no
thermal warning
The drive is ready for operation in auto-on mode, and no thermal warning is present.
[24]
Ready, Voltage OK
The drive is ready for operation and mains voltage is within the specified voltage range.
[25]
Reverse
The motor runs/is ready to run clockwise when logic = 0 and counterclockwise when logic = 1.
Output changes as soon as reversing signal is applied.
[26]
Bus OK
Active communication (no timeout) via serial communication port.
[35]
External Interlock
See digital input.
[36]
Control word bit 11
Bit 11 in control word controls the relay.
[37]
Control word bit 12
Bit 12 in control word controls the relay.
[41]
Below reference, low
The reference is lower than the limit set in
parameter 4-54 Warning Reference Low
.
[42]
Above ref, high
The reference is higher than the limit set in
parameter 4-55 Warning Reference High
.
[45]
Bus Control
The output is configured in
parameter 5-90 Digital & Relay Bus Control
.
[60]
Comparator 0
See
parameter group 13-1* Comparators
. If comparator 0 is evaluated as true, the output goes
high. Otherwise, it is low.
[61]
Comparator 1
See
parameter group 13-1* Comparators
. If comparator 1 is evaluated as true, the output goes
high. Otherwise, it is low.
[62]
Comparator 2
See
parameter group 13-1* Comparators
. If comparator 2 is evaluated as true, the output goes
high. Otherwise, it is low.
[63]
Comparator 3
See
parameter group 13-1* Comparators
. If comparator 3 is evaluated as true, the output goes
high. Otherwise, it is low.
[64]
Comparator 4
See
parameter group 13-1* Comparators
. If comparator 4 is evaluated as true, the output goes
high. Otherwise, it is low.
[65]
Comparator 5
See
parameter group 13-1* Comparators
. If comparator 5 is evaluated as true, the output goes
high. Otherwise, it is low.
[70]
Logic rule 0
See
parameter group 13-4* Logic Rules
. If logic rule 0 is evaluated as true, the output goes high.
Otherwise, it is low.
[71]
Logic rule 1
See
parameter group 13-4* Logic Rules
. If logic rule 1 is evaluated as true, the output goes high.
Otherwise, it is low.
[72]
Logic rule 2
See
parameter group 13-4* Logic Rules
. If logic rule 2 is evaluated as true, the output goes high.
Otherwise, it is low.
[73]
Logic rule 3
See
parameter group 13-4* Logic Rules
. If logic rule 3 is evaluated as true, the output goes high.
Otherwise, it is low.
[74]
Logic rule 4
See
parameter group 13-4* Logic Rules
. If logic rule 4 is evaluated as true, the output goes high.
Otherwise, it is low.
[75]
Logic rule 5
See
parameter group 13-4* Logic Rules
. If logic rule 5 is evaluated as true, the output goes high.
Otherwise, it is low.
AU363928304090en-000101 / 130R0982 | 87
Danfoss A/S © 2021.07
Parameters
VLT® Flow Drive FC 111
Programming Guide
