CTC Union GSW-3208M1, Руководство пользователя

Страница: 98 / 240

95
5.
quit
command
This command is used to quit from console interface. It has the same
function as logout.
6.
interface
command
This command is used to change to another interface VLAN groups for next
setup commands.
(config-if)# interface ?
vlan Sw itch Virtual LAN interface
For example,
“(config-if)# interface vlan 100” will change the s etup interface to VLAN 100
and all following commands will be applied to VLAN 100.
7.
ip
command
This command is used to set IP address of the switch on this VLAN interface.
And only users in this VLAN can access this switch with the IP address
remotely.
(config-if)# ip address ?
dhcp Dynamic host configuration protocol
A.B.C.D IP address
renew Renew IP
ip address dhcp
command is used to enable DHCP client function. DHCP
client function will try to get IP configuration from DHCP server in network.
And
no ip address dhcp
command can be used to disable it.
If DHCP fails and the configured IP address is zero, DHCP will retry. If DHCP
server does not respond around 35 seconds and the configured IP address
is non-zero, DHCP will stop and the configured IP settings will be used. The
DHCP client will announce the configured System Name as hostname to
provide DNS lookup.
ip address x.x.x.x y.y.y.y
command is used to set IP address of the switch on
this VLAN.
“
x.x.x.x
” is the IP address. “
y.y.y.y
” is the subnet mask.
For example, “ip address 192.168.1.12 255.255.255.0” will set the IP address
of the switch on this VLAN group for remote management.
ip address renew
command is used to refresh the lease time of the IP
address got by DHCP. If IP configuration is not got when boot-up, this
command will try to get IP configuration again.