CTC Union GSW-3208M1, Руководство пользователя

Страница: 97 / 240

94
Note: The general VLAN settin
gs are done with “
vlan database
” command.
Please refer to section
6.2.5 VLAN Configuring Commands
for the details.
And
interface vlan x
command is used to assign characteristics to a VLAN
group interface. For example, assigning IP address to a VLAN inte rface is
done with this command.
Entering “interface vlan 100”, and its prompt will become ...
(config)# interface vlan 100
(config-if)#
Enter “?” at the prompt, the sub-command list will be shown.
----------------------------------------------------------------------------------------------
(config-if)# ?
exit Exit from current mode
help Show available commands
history Show a list of previously run commands
logout Disconnect
quit Quit commands
interface Enters privileged interface configuration
ip Set the IPv4 setup
ipv6 Set othe IPv6 setup
no Negates a command or sets its defaults
----------------------------------------------------------------------------------------------
1.
exit
command
This command is used to leave current operation mode. Go back to last
mode.
2.
help
command
This command is used to show all the available commands in this mode.
3.
history
command
This command is used to show the history of entering commands.
4.
logout
command
This command is used to logout from console interface.