CTC Union GSW-3208M1, Руководство пользователя

Страница: 88 / 240

85
maximum number and its valid value is 0-1024. For example, x=5 will allow
up to five network devices / PC access network through the inter face port(s).
If the limit is exceeded, the corresponding action is taken.
The switch is "born" with a total number of MAC addresses from which all
ports draw whenever a new MAC address is seen on a Port Security-enabled
port. Since all ports draw from the same pool, it may happen that a configured
maximum cannot be granted, if the remaining ports have already used all
available MAC addresses.
port security mode
command is used to enable Limit Control on this port.
And “
no port security mode
“ command is used to disable it. Both this and
the Global Mode must be set to Enabled for Limit Control to be in effect.
port security reopen
command is used to reopen a shutdown port that is
shuted down by the port security function.
27
port-vlan
command
This command is used to assign the interface port(s) to a Port-based VLAN.
port-vlan x
command will assign the interface port(s) to a Port-based VLAN.
“
x
” is the index of the Port-based VLAN with value 1-10. And “
no port-vlan
x
“ command is used to remove the interface port(s) from a Port-based VLAN.
port-vlan isolation
command is used to put the ports to the isolation port
group. Memebers in the isolation port group will be isolated to each other
even they are in the same VLAN. And “
no port-vlan isolation
“ command is
used to remove the ports from the isolation port group.
28
power-control
command
This command is used to configure the power-control function for the
interface port(s).
power-control [actiphy | disable | perfectreach | enable]
command is used
to set the the power savings mode for the interface port(s).
-
actiphy
: Link down power savings enabled.
-
disable
: Disable all power control.
-
perfectreach
: Link up power savings enabled.
-
enable
: Both link up and link down power savings.
29
qos
command
This command is used to configure QoS function on the interface port(s).
(config-if)# qos ?
classification QoS Ingress Port Classification