CTC Union GSW-3208M1, Руководство пользователя

Страница: 59 / 240

56
set to 0 (zero), the default port (1813) is used.
Configure the operation parameters ...
radius-accounting-server dead-time x
command is used to specify Dead
Time of Common Servers. “
x
” is the Dead Time with a number between 0
and 3600 seconds.
The Dead Time is the period during which the switch will not send new
requests to a server that has failed to respond to a previous request. This will
stop the switch from continually trying to contact a server that it has already
determined as dead.
Setting the Dead Time to a value greater than 0 (zero) will enable this feature,
but only if more than one server has been configured.
radius-accounting-server timeout x
command is used to specifies Time Out
of Common Servers. “
x
” is the Timeout with a number between 3 and 3600
seconds. The Timeout is the maximum time to wait for a reply from a server.
If the server does not reply within this time frame, we will consider it to be
dead and continue with the next enabled server (if any).
RADIUS servers are using the UDP protocol, which is unreliable by design. In
order to cope with lost frames, the timeout interval is divided into 3
subintervals of equal length. If a reply is not received within the subinterval,
the request is transmitted again. This algorithm causes the RADIUS server to
be queried up to 3 times before it is considered to be dead.
32
radius-authentication-server
command
This command is used to configures RADIUS Authentication Server. Up to
five RADIUS Authentication Servers are supported. The following is the
details of the command.
Configure the server ...
radius-authentication-server x active
command is used to activate RADIUS
Authentication Server “x”. “
x
” is the server index number between 1~5.
radius-authentication-server x host y.y.y.y
command is used to assign IP
address to RADIUS Authentication Server “x”. “
x
” is the server index number
between 1~5. “
y.y.y.y
” is a IP address.
radius-authentication-server x key yyy
command is used to assign the
secret key “yyy” to RADIUS Authentication Server “x”. “
x
” is the server index
number between 1~5. “
yyy
” is the secret key - up to 29 characters long -
shared between the RADIUS Authentication Server and the switch.
radius-authentication-server x port y
command is used to assign the UDP
port to use on the RADIUS Authentication Server. “
x
” is the server index
number between 1~5. “
y
” is the UDP port number between 0~65535. If the
port is set to 0 (zero), the default port (1812) is used.
Configure the operation parameters ...