CTC Union GSW-3208M1, Руководство пользователя

Страница: 74 / 240

71
this command will be applied to ports in this range. Fo
r example, “interface
ethernet 1/4-
7” and the settings after this command will be applied to Port 4,
Port 5, Port 6, and Port 7. (Port 4~7)
4.
interface ethernet 1/w,x,..,y-z
and “
w
”,”
x
”,”
y
”,”
z
” are port number. All the
settings after this command will be applied to those ports. For example,
“interface ethernet 1/1,2,4-7” and the settings after this command will be
applied to Port 1, Port 2, Port 4, Port 5, Port 6, and Port 7. (Port 4~7)
Entering “interface ethernet 1/5”, and its prompt will become ...
(config)# interface ethernet 1/5
(config-if)#
Enter “?” at the prompt, the sub-command list will be shown.
----------------------------------------------------------------------------------------------
(config-if)# ?
exit Exit from current mode
help Show available commands
history Show a list of previously run commands
logout Disconnect
quit Quit commands
acl Access Control List Configuration
arp-inspection Set ARP inspection configuration
channel-group Adds ports to a trunk
dhcp-snooping Configures DHCP Snooping Configuration
dot1x Configures 802.1x port-based access control
eee Set the eee mode
end Exit from interface mode
excessive Configure port transmit collision behavior
flowcontrol Enables flow control during autoneg
interface Enters privileged interface configuration
ip Global IP configuration sub commands
ip-source-guard IP Source Guard Configuration
lacp Configures LACP status
lldp Configures lldp
loopback-detection Configures loopback detection
mac-learn mac learn
maximum -packet-length Configures the maximum packet length of the port
mdi/mdi-x Set MDI crossover
mvr Multicast VLAN Registration
no Negates a command or sets its defaults
port Configures the characteristics of the port
port-vlan Configures Port-Based VLAN
power-control Decrease energy consumption
qos Configuration of QoS